Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Bottom strike is dragging ”

Resolution: Required top and bottom rod adjustment. Top rod possibly is adjusted too short and not lifting the rod far enough to engage the latch retention which would cause bottom rod to drag floor ...:

Why would an EL1690 retract the rods but not hold them?.

Resolution: One of the following items may cause the EL1690 device to retract then release: Incorrect power supply - Verify you have the PS873-2/4TD or PS914-2RS/4RL power supply. Problems with wire gauge...:

Why would a 98/9927 bottom rod/latch drag?

Resolution: The following could cause the bottom latch on 98/9927 exit device to drag.The bottom rod is too long. Adjust bottom rod per the instructions.Top latch controls the bottom latch. Make sur...:

Why will my EL 1490 fire my latches but not hold?

Resolution: One of the following items may cause the EL1490 device to retract then release: Incorrect power supply - Verify you have the PS873-2/4TD or PS914-2RS/4RL power supply. Problems with wire gauge...:

Is the 2126A bottom strike still available?

Resolution: The 2126A strike was discontinued in 2009.:

Can an electric strike be used with a surface vertical rod device on a fire-rated door?

Resolution: Not for use in fire rated openings.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Bottom strike is dragging ”

RELATED FAQS