Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ cylinder plug finish ”

Resolution: The 7500 mortise lock should be configured for NL function as shipped not as Classroom. See figure 4-3 in E996L instructions.:

Can I put a Schlage Key-In-Lever cylinder into a Falcon D100 or D200 lock?

Resolution: For a Schlage "C" keyway: Specify "CP6" as the cylinder suffix when ordering D100 or D200 locks (All other Schlage keyways are not available).:

What would cause a key to get stuck in a cylinder?

Resolution: Check the following: Debris in the cylinder The cylinder cap could be too loose Incorrect pinning of the cylinder The cylinder plug is not returned to the neutral position with the cylinder s...:

Why is the plug pulling out of the FSIC 23-030 mortise housing?

Resolution: ISSUE: After some use the plug will begin to project from the cylinder face and will ultimately pull completely out. ROOT CAUSE: In a dogged application the cam was rotated 180 degrees which ...:

What are the part numbers for the Schlage blocking rings?

Resolution: After selecting the correct blocking ring, specify the thickness. The table below shows the different thicknesses that the rings are offered in. &...:

Do the Falcon exit devices have the double cylinder option?

Resolution: A double cylinder(-2) option is not available on a Falcon device but is available from Von Duprin.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ cylinder plug finish ”

RELATED FAQS