Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ el device requirements ”

Resolution: This option is not available as the solenoid is in the mechanism case where the dogging components would go. An HD-EL solenoid is not available, and Special Dogging(SD) is not an optio...:

Which electrified hinge is required or recommended for use with EL devices?

Resolution: Recommend at least a 4 wire hinge and double up the wires for EL application.:

What is the power output of a 4600 operator?

Resolution: The 4600 Series operator has both a 12VDC and 24VDC output rated at 1A (combined load) to power strikes, maglocks, and other devices, but an EL device must have a separate Power Supply for motorize...:

What gauge wire is needed for CX red and black power wires?

Resolution: For Product Shipped prior to 8-24-2015 with solenoid and EPT or Door Loops: a. 0-100 ft, use #14 Gauge Wire ...:

What power supply is needed for EL devices?

Resolution: You can use a Von Duprin PS914 power supply with any of the following option boards depending on the application. 900-2RS board will power 1 or 2 devices that do not require timing from pow...:

Is the Von Duprin EL option available on Von Duprin XP98 or XP99 exit devices?

Resolution: The EL (Electrified) option is available with Von Duprin XP98/99 exit devices. To order, specify ELXP98/99 with proper trim.:

Is the PS 914-2RS required for EL operation?

Resolution: The PS914-2RS is the required power supply to operate 1 or 2 EL devices.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ el device requirements ”

RELATED FAQS