Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ FIRE/LIFE HOLD OPEN ”

RELATED FAQS

Resolution: Hold Open Closers & Magnets (Fire/Life safety products) provide a wide range of solutions. Single or multi-point hold open closers Utilize an electromechanical closer. Hold the door o...:

Can a Cam Lift hinge be used with LCN closers?

Resolution: Cam Lift hinges can only be used with LCN door closers that have a "Regular" or "Reg hold Open" style arm. Locating the Closer and Arm from the centerline of the pivot point of the cam lift h...:

Can you manually pull a 4040SE out of hold open?

Resolution: The holding force on an SE/ME Series door closer is approximately 35 lbs. and they can be manually pulled out of hold open with approximately 35 lbs of force. :

How do I wire an EL device to normally hold open the latch and release it during a fire alarm?

Resolution: Use a normally closed fire alarm as the input to the power supply option board (PS873-2 or PS914-2RS), this will hold the latch retracted. During a fire alarm, the contact will open, dropping...:

What would cause an ME Series closer (2310ME/4310ME/4410ME) to pop back into hold open as it is closing?

Resolution: This condition can be caused by the "closing speed adjustment" being regulated for a fast closing speed. Try adjusting the closing speed to slow down the closing of the door. If that does not corre...:

Can a magnet, or sentronic device, be released and close the door from a button at a desk?

Resolution: If a door is being held open by the LCN SEM 7800/1900 magnet or any ME/SE Series Sentronic LCN closer, you can remotely release that door to close by ordering the following parts and wiri...: