Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ handle gets hot ”

Resolution: If the solenoid of the 6000 series electric strike is powered continuously with proper voltage at room temperature, the solenoid can feel very warm to the touch. Ensure the power supply ...:

Should a solenoid be hot to the touch?

Resolution: If there is concern that the solenoid or device is "too hot" or has the capability to cause injury, disconnect the device and contact a authorized service representative to analyze the opening.:

Why is my E996L solenoid getting hot?

Resolution: This is usually an indicator of applying excessive voltage. Measure the voltage going into the solenoid and make sure you have 24-26.4VDC cross the two wires going into the solenoid. Also measure ...:

How does the Von Duprin 88TP convert to an 88L?

Resolution: Followings are the steps to convert the Von Duprin 88TP to 88L device. Need to replace the back plate on the 88 exit device, part number 050103. Order a 373L trim and specify handing. Recomme...:

Can the Von Duprin 996L lever handle be replaced with a new one?

Resolution: Yes, Von Duprin 996L lever handle can be replaced with a new one . Attached installation instructions shown how to replace the existing lever handle on 994/996L trim for rim and vertical rod device...:

What is the minimum and maximum PSI applied to a 4800 operator?

Resolution: The pneumatic operators are designed to function with an input air pressure to the 7901/7902 Series control box of 80 (min) 100 (max) PSI, and an output pressure of 60 to 80 PSI to the pneumatic (2...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ handle gets hot ”

RELATED FAQS