Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Installing electric Latch retraction ”

Resolution: Use a normally closed fire alarm as the input to the power supply option board (PS873-2 or PS914-2RS), this will hold the latch retracted. During a fire alarm, the contact will open, dropping...:

How does the latch bolt retract on the Von Duprin XP device?

Resolution: The latch bolt on an XP98/99 exit device does not retract. The latch bolt will release and pivot out of the way when push bar is depressed or out side trim is activated.:

Is there an EL conversion kit for the Falcon 2390 exit device?

Resolution: There is no EL conversion kit for a 2390, the device will need to be replaced.:

How do you test a Falcon 24 or 25 Series EL solenoid?

Resolution: The resistance readings for a Falcon 24 or 25 Series EL solenoid should read;Green to Yellow = Pull Coil, should measure between 1 and 2 ohms of resistance. Green to Orange = Hold Coil, s...:

Can the Von Duprin EL option be added to any existing 98/99 device?

Resolution: The Von Duprin EL option can be added to any existing 33A/35A, 98/99 series exit devices. :

What power supply is needed for EL devices?

Resolution: You can use a Von Duprin PS914 power supply with any of the following option boards depending on the application. 900-2RS board will power 1 or 2 devices that do not require timing from pow...:

Has the Monarch 19 ever had electric latch retraction?

Resolution: Electric Latch Retraction(ELR) option for the 19 Series was discontinued in December of 2006.:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ Installing electric Latch retraction ”

RELATED FAQS