Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
momentary wall switch
”
RELATED FAQS
Question
Answer
Does wall board have to extend into the throat of a fire rated frame?
Resolution:
:
How to change switches on a 8200 Console to maintained or momentary?
Resolution:
To replace the pushbuttons, remove the switch connector from the console main board Then press the pushbutton from the inside of the panel face out through the hole. There will be some resist...:
What is an error code E04 on an LCN 4600?
Resolution:
An error - E 04 - is an indication of a constant activation input from either the "Hold Open" switch or a "Wall Activation" switch when the 4600 power is turned on. This condition also occurs when ...:
What components are needed to convert a hard wired actuator button to a wireless actuator button?
Resolution:
To convert an RF actuator button to a hard wired actuator button, simply remove the RF transmitter an connect the hard wiring to the "Common" and "Normally Open" terminals on the the switch.:
What are the ANSI recommendations for the actuator mounting height and distance between the wall actuator and the door opening?
Resolution:
Always check the most current revision of the ANSI A156.19 standard for recommendation or requirement of the location of a Knowing Act switch. 2019 ANSI A156.19 states the requirement of the ...:
What is the read range of the new Schlage MT11 wall mounted reader?
Resolution:
All read ranges are affected by the environment the reader and card are subjected too. The following data was obtained in a relatively "noisy" RF area with the reader mounted on a metal ...: