Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ solenoid for old ELR ”

Resolution: It can but the solenoid will need to be purchased through New England Door Closer as the factory discontinued the old ELR solenoid (part #650092-000) in June 2010.:

How do you test a Falcon 24 or 25 Series EL solenoid?

Resolution: The resistance readings for a Falcon 24 or 25 Series EL solenoid should read;Green to Yellow = Pull Coil, should measure between 1 and 2 ohms of resistance. Green to Orange = Hold Coil, s...:

What Von Duprin solenoid crosses over to the solenoid part number 971687?

Resolution: If you are trying to replace Von Duprin EL solenoid part number 971687, the sellable part number for the solenoid and plunger is 050535. Please note that the solenoid is rarely the cause of E...:

Will the PS914 or PS873 replace the RDS-2?

Resolution: This is not an option, the older RDS-2 was used with the older Falcon Monarch ELR devices. The power supply would apply 24VDC for 1 second then drop down to 5VDC for the remainder of h...:

Is the 900-ELK wiring adaptor required when using the PS914 power supplies?

Resolution: Products shipped on or after August 8, 2012 no longer require the EL wiring adaptor. The ELK Wiring Adaptor (900ELK) was used only when using the PS914 power supply with either the 900-2RS or...:

How is a ELR or panic device wired to a Senior Swing?

Resolution: EL devices are wired to the Senior Swing, using the P10 (761465) cable. Connect the "GRAY" wire to the SC terminal on the 900-2RS card in the Von Duprin Power Supply and the "VIOLET" wire to the ...:

Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ solenoid for old ELR ”

RELATED FAQS