Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

“ steelcraft shop drawings ”

RELATED FAQS

Resolution: Approved Submittal Drawing:

Are there autoCAD drawings available for Allegion products?

Resolution: AutoCAD drawings are proprietary and are not available for distribution. :

What are the Falcon T lock electrical requirements?

Resolution: Prior to June 2011 the T lock only supported 24V and the electrical requirements were as follows: 0.185 amp @ 24VDC Wire Gage 22 AWG See wiring diagram here - (Previous 2 wire versi...:

Can Steelcraft doors be powder coated?

Resolution: Steelcraft does not offer factory powder coated doors and/or frames. Powder coatings usually require heat between 300 to 400 degrees to melt and cure the powder coat. The higher heat can ca...:

What current should an AD-Series or CO-Series lockset draw while in its low power "Sleep" mode?

Resolution: Use a multi-meter in series with the batteries to measure battery current. Be sure your multi-meter can accurately measure very low current, in the micro-amp range. See the attached Technical Not...: