Allegion
Terms of Use
Privacy Policy
Frequently Asked Questions
Ask your question
Entering your question as a complete sentence will provide more accurate results than keywords or phrases.
User questions
FAQs
Category List
“
Well calibration button
”
RELATED FAQS
Question
Answer
Why would QEL retract and release repeatedly?
Resolution:
The following could cause the QEL device to retract and release repeatedly: If this is a vertical rod type device, the vertical rods could be adjusted too short. Check rods for dead locking, ...:
Why does the QEL cycle 3 times with a solid red led and does not work?
Resolution:
Improper mechanical adjustment or QEL calibration could cause the QEL cycle three times with solid LED and not work. First check mechanical adjustment on vertical rods or mortise lock device and co...:
How is the QEL calibrated?
Resolution:
The QELA motor that has shipped since 2015 is self calibrating. Older versions had a calibration button, and these notes would apply: Calibration is an internal process of the QEL device&...:
Camera calibration on a hand reader, what should the row (r), column (c), and exposure (e) calibration values be to indicate proper camera alignment?
Resolution:
On a biometric F-Series or E-Series hand reader, the desired row (r) value and column (c) value should each be zero (0), plus or minus 2. The desired exposure (e) value sh...:
How do you get the camera calibration values on a biometric F-Series HandPunch?
Resolution:
To get the camera calibration values on a biometric F-Series HandPunch or F-Series HandKey, press the * (asterisk) key 11 times. It will display R (row), C (column), and E (exposure)...:
How do I get into the menus on a biometric HandKey in order to enroll a user?
Resolution:
The HandKey II Command Mode Structure is used to access all menus in the HandKey. You hit clear and enter for the reader to ask ENTER PASSWORD if its a new reader. You hit clear and enter followed ...: