Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

If you turn on Degraded Cache Mode on your AD locks, what does this feature do?

Resolution: Once degraded cache mode is turned on, it will start saving granted access cards in its cache memory for allowing access when the locks go offline.:

Does the Schlage Encode Series Perform Routines?

Resolution: The Schlage Encode Series does not have the built-in capability to create routines on its own. However, you can enable routines by pairing your Encode lock with a "Works With" partner through the S...:

Is the pin removable from the 1010 door hinge

Resolution: The pin on the Schlage 1010 door hinge is removable. You will need a flat head screw driver and a a hammer to gently remove the caps from the hinges to allow the pin to be removed. :

What is the approximate weight of a RX-98-L w/trim?

Resolution: The weight of the exit device and trim are approximately 19 lbs total.Approximately 15 lbs for the exit deviceApproximately 4 lbs for the trim:

Has the Oil Rubbed Bronze(613) finish been discontinued?

Resolution: Oil Rubbed Bronze has been discontinued.Schlage locks are still covered by a limited lifetime mechanical warranty, in the instance a replacement is needed Aged Bronze(716) will be sent as a substit...:

Is the 1260 Cush arm the same as the 1460 Cush arm?

Resolution: The Cush and HCush arms are the same for the 1260 and 1460 series closers.:

Can the 80-102 mortise cylinder be ordered with other blocking ring sizes?

Resolution: The 80-102 mortise cylinder can be ordered with blocking rings in 1/8", 3/16", ¼", 5/16", 3/8", 7/16" and ½" thicknesses. Specify the required blocking ring thickness when ordering. :

Can the 80-132 mortise cylinder be ordered with other blocking ring sizes?

Resolution: The 80-132 mortise cylinder can be ordered with blocking rings in 1/8", 3/16", ¼", 5/16", 3/8", 7/16" and ½" thicknesses. Specify the required blocking ring thickness when ordering. :

Can the 80-302 mortise cylinder be ordered with other blocking ring sizes?

Resolution: The 80-302 mortise cylinder can be ordered with blocking rings in 1/8", 3/16", ¼", 5/16", 3/8", 7/16" and ½" thicknesses. Specify the required blocking ring thickness when ordering. :

Can the Falcon 8200 operator power two wave actuators?

Resolution: The 8200 series Falcon operator has enough output power to power up two wave actuators but the 8200 only has .25 amp maximum output power and will be close to being maxed out.: