Ask your question Entering your question as a complete sentence will provide more accurate results than keywords or phrases.

FAQs

What is the fuse information for a PS873 power supply?

Resolution: The PS873 (discontinued in January 2011) uses a slow blow 4A, 250V, 1/4" x 1 1/4" fuse. A slow blow fuse is required because the EL device 16 amp surge would ruin an ordinary fuse. To c...:

When did the Von Duprin 22 Series center case cover design change?

Resolution: The design changed in April 2020. The new cover design is backward compatible. The new covers received new sellable part numbers, and the old part numbers became obsolete. Whe...:

Will a Medeco full size IC core fit into a Schlage FSIC housing?

Resolution: The Medeco 31 and the Medeco 32 FSIC will not fit into a Schlage FSIC mortise or rim housing.:

What is a flashing red and green on an EN-201 the cannot find the IP address?

Resolution: Red or yellow and green LEDs are both ﬂashing: • This means the Ethernet cable has been detected but IP address entered at the reader has not been sent to the Ethernet adapter yet. This status...:

Is the 672 Series Push Bar UL rated?

Resolution: Yes, it is, UL 294 and UL1034:

What card emulation’s can a MTK-15 have?

Resolution: The only card emulation from the MTK-15 is 26-bit with facility code, for keypad output.:

What is the 5 pin port above the main connector port on the MT15/MTK15 used for?

Resolution: That is used to conned a magstripe reader.:

Can a HID CSN 40 show what parity is on the card?

Resolution: There's no parity for CSN, it's a number only, no parity, facility code or badge ID.:

How will an NDE react if its in an unlock schedule and someone presents a card?

Resolution: If it's a valid card being presented, beep and two greens If its an invalid card... beep and 2 red LED's The lock will continue to be unlocked :

What is the difference between the 692 SmartBar and 672 TouchBar?

Resolution: The 672 just has a switch in it that open and closes when pressing on the push bar. The 692 does not move and uses an infrared light sensor across the front of the bar to activate a relay when...: