Category: Guard X

(Results from 1 to 7)
Is there a template for the 267 strike?
See attached template for the 267 strike....
Schlage Commercial » Exit Devices » Touch Bar » Guard X
Is the Von Duprin Guard X 2670 device hurricane rated (HH)?
The HH2670 is only approved for use on single flush doors per NOA 15-0826.23 and FBC FL#12400.3.  It is shown using the 267 strike and has a design pressure rating of +/-55 PSF. ...
Schlage Commercial » Exit Devices | Schlage Commercial » Exit Devices » Touch Bar » Guard X | Schlage Commercial » Exit Devices » Touch Bar » Guard X » Von Duprin
2670 alarms when retracting bolt with key
Remove device cover.Remove Rim cylinder and mounting cup.Rotate cam with cross-hairs counter clockwise until it stopsRotate clock-wise about 1/4 turn until notch on plate lines up with notch on bracke...
Schlage Commercial » Exit Devices | Schlage Commercial » Exit Devices » Touch Bar | Schlage Commercial » Exit Devices » Touch Bar » Guard X | Schlage Commercial
What is the purpose of the pan head screw on the back of the 2670 Guard-X device chassis?
This screw sits next to the cylinder input cam and it keeps the pull side cylinder cam from rotating.  If a cylinder will not be used for the pull side, the screw should remain installed. ...
Schlage Commercial » Exit Devices » Touch Bar » Guard X | Schlage Commercial » Exit Devices » Touch Bar » Guard X » Von Duprin
If I am using the PT790 transformer to power the Guard-X 2670, is it required to install the 9V battery?
The battery does not have to be installed in order for the transformer to work; but if the battery is installed, it will serve as power backup if AC power is lost....
Schlage Commercial » Exit Devices » Touch Bar » Guard X | Schlage Commercial » Exit Devices » Touch Bar » Guard X » Von Duprin
On the PT790 transformer cable, which way do I install it to the circuit board? Which wire is Ground?
As of April 2017, the red wire is Ground. When installing the connector to the Guard-X 2670 circuit board, the red wire should face toward the circuit board....
Schlage Commercial » Exit Devices » Touch Bar » Guard X | Schlage Commercial » Exit Devices » Touch Bar » Guard X » Von Duprin
Can you use a 230NL or 210NL with a 2670 Guard-X?
The Guard-X device must have a Rim Cylinder installed in the head of the device to extend the bolt which also arms the device or retract the bolt which also disarms the device.If desired, a Rim Cylind...
Schlage Commercial » Exit Devices » Touch Bar » Guard X

Support by product